Table of Contents
Advertisement
17. Serial port connectors (10-1 pin COM2, COM3, COM4, COM5)
These connectors are for serial (COM) ports. Connect the serial port cables
to these connectors, then install the module to a slot opening at the back of
the system chassis.
A
Connector type
NOTE: The serial port cables are purchased separately.
18. Flat panel display brightness connector (5-pin LCD_BLKT_PANEL)
This connector is for the LCD panel brightness controls.
Connector type
Chapter 2: Motherboard information
A
C
B
B
D
C
D
BOX header 2x5p, K10, 2.0mm pitch
LVDS Signal
PIN1
WAFER 6p, 2.0mm pitch
COM3
COM4
COM5
COM2
PIN 1
LCD_BLKT_PANEL
eDP Signal
PIN1
2-23
Advertisement
Table of Contents
