Kärcher T 400 T-Racer Manual page 8

Application
Note: Always use Kärcher water filter (or-
der no. 4.730-059.0) during suction opera-
tions of the high-pressure cleaner.
Cleaning floor surfaces
Fasten the T-Racer to the high-pressure
gun using the extension pipes.
Illustration
1 Screw the two extension pipes togeth-
er.
2 Press the extension pipe into the bayo-
net catch of the T-Racer.
3 Turn it by 90° until it locks into place.
4 Tighten the safety cover.
Illustration
1 Press the extension pipe into the bayo-
net catch of the high pressure gun.
2 Turn it by 90° until it locks into place.
3 Tighten the safety cover.
 Adjust the turning handle "power" as
per the surface to be cleaned
Tips for cleaning
Caution
 Outdoor surfaces should be swept be-
fore the T-Racer is used to avoid dam-
aging the high-pressure nozzles.
 Prior to use on sensitive surfaces (e.g.
wooden surfaces), test the product on
an imperceptible spot, in order to
promptly detect any changes in the sur-
face.
 The T-Racer is not suited for scouring
or scrubbing!
Illustration
 Do not run over protruding corners!
8
Cleaning wall surfaces
Fasten the T-Racer directly to the high-
pressure gun.
 Press the bayonet connection of the T-
Racer into the connection of the high-
pressure gun, then turn by 90° until it
locks into place.
 Tighten the safety cover.
Illustration
Caution
 Always hold the T-Racer at the handle
while cleaning the walls.
 Adjust the turning handle "power" as
per the surface to be cleaned
Control elements
"Power" turning handle
The turning handle "power" is used to
change the distance of the high-pressure
nozzles to the surface to be cleaned.
Robust surfaces (for e.g. tiles, concrete,
stone)
Illustration
 Set turning handle "power" to "HARD".
For the effective cleaning of hard-to-re-
move contamination.
Sensitive surfaces (for e.g. wood)
Illustration
 Set turning handle "power" to "SOFT".
For the gentle cleaning of sensitive sur-
faces.
Foot pedal for surface cleaning
Illustration
 For normal surface cleaning, press the
foot pedal for surface cleaning.
A water stream will be emitted from the
two high-pressure nozzles in the rotor
arm.
Foot pedal for edge cleaning
Illustration
 For edge and corner cleaning, press the
foot pedal for edge cleaning.
A water stream will be emitted from
green high-pressure nozzle.
– 2
EN