VESTEL MB120 DS Service Manual page 48

The connector used for the Pluggable Module and the docking board interconnect is based on the JAE
TX24/TX25 family of plug and receptacle connectors. The JAE connector pins are capable of supporting up to
a maximum current of 1A. For details refer to the JAE connector datasheet or contact a JAE representative. The
80-pin right angle blind mate plug connector (p/n: TX25-80P-LT-H1E) and its receptacle (p/n: TX24-80R-LT-
H1E) provide interfacing for the following features:
Power: DC IN +12V~+19V @ 8A max
Display Interface: DVI-D/TMDS and DisplayPort
Audio: Left and Right Channel
USB: 3*USB 2.0 (when USB3.0 is not used) or 2*USB 2.0 and 1*USB 3.0
UART: Serial communication (Tx and Rx only)
Control Signals: Pluggable Module Power Status, Power ON via display panel, Pluggable Board Detect,
Consumer Electronics Control (CEC), and System Fan Control.
47
Figure 22: Functional Block Diagram