Table of Contents
Advertisement
INSTALL HOPPER IN VEHICLE BED
NOTE: Periodically throughout the snow and ice
control season, verify that mounting devices
are secure.
1. Remove the vehicle tailgate.
2. Remove the wood shipping rails from the hopper legs.
Lit. No. 31002/31004, Rev. 00
MOUNTING THE SPREADER
10
CAUTION
Before lifting, verify that the hopper is empty
of material. The lifting device must be able to
support the spreader's weight as shown in
the Spreader Specifications table.
3. Using slings or chains, lift the spreader by all four
diagonal corner rails and move it into the vehicle bed.
Use all four rails
when lifting.
4. Center the spreader from side to side. Shift the
spreader forward or backward to a position that
will allow the chute, once installed, to overhang
the rear of the vehicle and the bumper. With two
people, trial-fit the chute to check for clearance.
June 1, 2022
Advertisement
Table of Contents
