Page 1
Bassinet with Canopy Instruction Manual months MAXIMUM WEIGHT OF CHILD THE ILLUSTRATIONS SHOWN IN THIS MANUAL ARE FOR REFERENCE ONLY. THE MANUFACTURER RESERVES THE RIGHT TO CHANGE ANY SPECIFICATION OR FEATURE WITHOUT FURTHER NOTICE. IMPORTANT! PLEASE READ CAREFULLY BEFORE USE AND KEEP FOR FUTURE REFERENCE.
1 Safety Notes CAUTION: Read these instructions carefully before assembly and use and keep for future reference. The child may be hurt if you do not follow these instructions. WARNING! This product is intended for use for babies aged between 0 and 6 months, weighing up to a maximum of 9kg.
Page 3
1 Safety Notes (continued) WARNING! WARNING! Placing additional items in the product may cause su ocation. WARNING! Do not place the product close to another product, which could present a danger of su ocation or strangulation, e.g. strings, blind/curtain cords etc. WARNING! Do not use more than one mattress in the product.
2 Battery Safety ATTENTION! BATTERY SAFETY: KEEP FOR FUTURE REFERENCE CAUTION! To prevent possible battery leakage, be sure to follow the guidelines outlined below: Alkaline batteries are recommended for longer battery life. Do not mix old and new batteries. ...
3 Parts List base board mattress with bassinet sheet canopy legs with storage feet night light, sounds foot tubes & vibration unit storage bag...
Page 6
4 Assembly Unpack all contents and check that all parts are present before starting assembly. Please refer to the parts list. 1. Turn the bassinet (A) upside down so that the frame leg joins are facing upwards. To unfold, pull the leg joins apart until the bassinet base is straightened and you hear a “click”.
Page 7
4 Assembly (continued) 3. Connect the feet (F) by inserting a foot tube (G) into the tube housing of both feet until the release button “clicks” into place. Repeat for the other side. “CLICK” Foot Foot Bottom Bottom 4. Connect each assembled foot tube section into the legs, ensuring to “click” in place.
Page 8
4 Assembly (continued) 5. Insert the base board (B) with hinge side down underneath the mattress (C), and cover using the mattress sheet. Turn the assembled bassinet over and place the board with mattress and sheet inside the bassinet. 6. To assemble the canopy, stretch canopy (D) over the frame. The insect net is part of the canopy and may be unfolded for use, or re-folded within the canopy when not in use.
Page 9
5 Folding 1. If the canopy is attached to the bassinet, you must remove it by undoing the press studs on each side of the bassinet. 2. Press the centre buttons on each side of the fabric cover as per below image.
Page 10
6 Night Light Unit 1. The unit requires 3 x AA 1.5 Volt batteries. To fit or replace the batteries: Loosen the screw on the battery compartment cover using a suitable screwdriver and remove the battery compartment cover. Remove the spent batteries and replace with new batteries ensuring that they have been inserted with the correct polarity as shown on the inside of the battery compartment.
7 Care and Maintenance 1. Turn bassinet upside down. 2. Undo the side flaps (with press studs) from the frame. 3. Unzip fabric at each end to remove, wash and air dry. Care Wipe plastics and metals with a damp cloth. A mild disinfectant may be used. ...
Page 12
KEYCODE: 43140800 MADE IN CHINA FOR AU / NZ: IMPORTED FOR KMART STORES IN AUSTRALIA AND NEW ZEALAND. KMART CUSTOMER SERVICE AU: 1800 124 125 NZ: 0800 945 995...
Need help?
Do you have a question about the 43140800 and is the answer not in the manual?
Questions and answers