Download Print this page

Advertisement

Quick Links

Advertisement

loading
Need help?

Need help?

Do you have a question about the Wooden Cot In Oak Colour and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for anko Wooden Cot In Oak Colour

  • Page 2 Read these instructions carefully before use and keep for future reference. The child may be hurt if you do not follow these instructions. Supplied loose in box M6*55mm M6*40mm M6*35mm M6*15mm (Pre-assemble)
  • Page 3 H x4 Do not firmly tighten bolts / screws. H x4 Pre-drilled holes face inside. I x2 H x4 I x2 J x8 J x4 J x6 G x4...
  • Page 4 G X4 J X4...
  • Page 5 Mattress Base in Low Position This base height is set for an active baby who can sit up unaided.
  • Page 6 I X4 K X4 Carefully slide Lay Cot on Side Panel. mattress base down Remove mattress to lower height base bolts. setting until dowels Remove Lower setting align with lower mattress base fitting dowel holes. bolts. I X4 Lay Cot on Top Re-fit mattress base side.
  • Page 8 WARNING: ADULT ASSEMBLY REQUIRED: DUE TO THE PRESENCE OF SMALL PARTS DURING ASSEMBLY, KEEP OUT OF REACH OF CHILDREN UNTIL ASSEMBLY IS COMPLETE. TO PREVENT FALLS, THE MATTRESS BASE OF THIS COT SHOULD BE ADJUSTED TO THE LOWEST POSITION BEFORE THE CHILD CAN SIT UP UNAIDED.
  • Page 9: Care And Maintenance

    the gaps between the mattress and the sides and ends of the cot will not exceed 40 mm when the mattress is pushed to one side or end, and 20mm when the mattress is centred in the cot. This is to minimise the danger of a child’s limb becoming caught in the gap. the depth of the cot is greater than 500mm with the mattress base in the lower position and is greater than 300mm with the mattress base in the upper...