Advertisement
Quick Links
2 TONE WOODEN COT
INSTRUCTION MANUAL
The photos and illustrations shown in this instruction manual are generic.
The manufacturer reserves the right to change any specification or feature without prior notice.
IMPORTANT. KEEP FOR FUTURE REFERENCE. READ CAREFULLY.
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for anko 42956426
Summary of Contents for anko 42956426
- Page 1 2 TONE WOODEN COT INSTRUCTION MANUAL The photos and illustrations shown in this instruction manual are generic. The manufacturer reserves the right to change any specification or feature without prior notice. IMPORTANT. KEEP FOR FUTURE REFERENCE. READ CAREFULLY.
- Page 2 Read these instructions carefully before use and keep for future reference. The child may be hurt if you do not follow these instructions. Supplied loose in box End Panel Side Panel Mattress Base 35mm Bolt x18 Allen Key Leg Mounting Panel Filler Bolt and Nut (Pre-assembled)x4 30mm Bolt x12...
- Page 3 To assemble Cot NOTE: Ensure that the bolt recesses are facing out. Attach both End Panels to one Cot should now resemble photo Carefully lay the cot down on the Side Panel using 4 x 30mm Bolts. obove. Side Panel. Tighten Until Firm.
- Page 4 Mattress Base Heights Mattress Base in High Position This base height is set for when your baby is young and can not sit up unaided. Mattress Base in Low Position This base height is set for an active baby who can sit up unaided.
- Page 5 To adjust Mattress Base Height NOTE: Loosening the bolts of one side panel will assist in avoiding any scratches or dents to your Cot whilst sliding the mattress base down to the lower position. If side panel bolts are loosened during this process, ensure they are re- tightened after you have moved Carefully lay the cot down on the...
- Page 6 WARNING: ADULT ASSEMBLY REQUIRED: DUE TO THE PRESENCE OF SMALL PARTS DURING ASSEMBLY, KEEP OUT OF REACH OF CHILDREN UNTIL ASSEMBLY IS COMPLETE. TO PREVENT FALLS, THE MATTRESS BASE OF THIS COT SHOULD BE ADJUSTED TO THE LOWEST POSITION BEFORE THE CHILD CAN SIT UP UNAIDED.
-
Page 7: Care And Maintenance
The width and length are specified because it is important that the gaps between the mattress and the sides and ends of the cot will not exceed 40mm when the mattress is pushed to one side or end, and 20mm when the mattress is centred in the cot. - Page 8 Keycode: 42956426 MADE IN CHINA FOR AU / NZ: IMPORTED BY KMART STORES IN AUSTRALIA AND NEW ZEALAND. KMART AUSTRALIA - 690 SPRINGVALE ROAD, MULGRAVE, VIC 3170 AUSTRALIA. KMART NEW ZEALAND - REGIONAL OFFICE C/O KMART PAPATOETOE STORE, HUNTERS PLAZA, GREAT SOUTH ROAD, PAPATOETOE,...
Need help?
Do you have a question about the 42956426 and is the answer not in the manual?
Questions and answers