General information regarding the CE marking HAMEG instruments fulfill the regulations of the EMC directive. The conformity test made by HAMEG is based on the actual generic- and product standards. In cases where different limit values are applicable, HAMEG applies the severer standard. For emission the limits for residential, commercial and light industry are applied.
Analog: Digital: 2 x DC to 150MHz, 2 x 1mV-50V/div Refresh, Single, Roll-, Envelope-, Average-,XY-Mode Time Base A with Trig. DC to 250MHz Max. Sampling Rate 200MSa/s, Storage 2x2048x8 bit Time Base B with 2ndTrig. to 250MHz Time Base A: 100s - 50ns/div., B: 20ms - 50ns/div. Trig.
Page 6
Typical board allocation Typical boards allocation (Top view) Digital - Board AT - Board AT - Board YF - Board Typical boards allocation (Back side) IF - Board Digital - Board YF - Board CT- Board Main - Board Typical boards allocation (Bottom view) YF - Board AT - Board CT- Board...
Need help?
Do you have a question about the HM1507-3 and is the answer not in the manual?
Questions and answers