System Admin Page Settings; System Admin > Setup Settings; System Admin > Change Password - Casio XJ-A235V Function Manual

System Admin Page Settings

System Admin > Setup Settings
Setting Name
IP Setup IP Address
Subnet Mask
DHCP Setup Auto/Disable
Starting IP Address
Ending IP Address
Wireless Setup SSID
SSID Broadcast
Channel
Security
Passphrase/WEP
Key
IEEE 802.11n
Channel Width
Show User Name Display
System Admin > Change Password
Setting Name
New Password
Reinput password
Specifies the projector IP address.
Initial Default: 192.168.100.10
Specifies a subnet mask value, which specifies the IP address range of the subnet
to which the projector belongs.
Initial Default: 255.255.255.0
Specifies whether an IP address should be assigned automatically to a computer
connected to the projector via wireless LAN. "Auto" causes an IP address to be
assigned automatically, while "Disable" turns off auto assignment.
Initial Default: Auto
Specifies the start point of the range of IP addresses that are assigned
automatically to computers. This setting is available only while "Auto" is selected
for the DHCP Auto/Disable setting.
Initial Default: 192.168.100.11
Specifies the end point of the range of IP addresses that are assigned
automatically to computers. This setting is available only while "Auto" is selected
for the DHCP Auto/Disable setting.
Initial Default: 192.168.100.254
Wireless network ID name. This is normally referred to as the SSID, ESS-ID, or
network name. Up to 24 single-byte alphanumeric characters can be entered.
Initial Default: casiolpj_default1 (casiolpj_default2 and casiolpj_default3 also are
built into the projector.)
Specifies whether SSID information broadcasting is enabled or disabled.
Initial Default: Enable
Specifies the channel used for wireless LAN communication. Selecting "Auto"
causes auto selection of a channel that is appropriate for the current
communication environment. To specify a channel number, select channel number
1 through 11 from the list that appears when you click the [  ] button to the right of
the channel number.
Initial Default: Auto
Specifies the security protocol. For more information, see "To configure security
settings" (page 21).
Initial Default: WPA-PSK AES
Specifies the passphrase or WEP key in accordance with the security protocol
selected with "Security" above. For more information, see "To configure security
settings" (page 21).
Specifies whether wireless LAN standard IEEE 802.11n is enabled.
Initial Default: Enable
Specifies either "20MHz" or "Auto" for the IEEE 802.11n channel width.
Initial Default: 20MHz
Specifies whether the computer's user name should appear on the projection
screen when projection starts from a computer connected to the projector via
wireless LAN.
Initial Default: On (User name displayed.)
For input of the new password when logging in to the System Admin page.
Initial Default: admin
Description
Description
36