Preparing The Hand Vacuum For Operation; Charging The Battery, Leds - Stihl SEA 20.0 Instruction Manual

5 Preparing the hand vacuum for Operation

■ Sharp cleaning agents, cleaning with a water
jet or pointed objects can damage the hand
vacuum, the battery and the charger. If the
hand vacuum, the battery or the charger is not
cleaned correctly, components may no longer
function properly or safety devices may be
rendered inoperative. They may cause serious
injury to persons.
► Clean the hand vacuum, battery and
charger as described in this instruction
manual.
■ If the hand vacuum, the battery or the charger
are not serviced or repaired correctly, compo‐
nents may no longer function properly or
safety devices may be rendered inoperative.
This may result in serous or fatal injury to peo‐
ple.
► Do not attempt to service or repair the hand
vacuum, battery or charger.
► If the hand vacuum, the battery or the
charger require servicing or repairs: Con‐
tact a STIHL servicing dealer for assis‐
tance.
5 Preparing the hand vac‐
uum for Operation
5.1 Preparing the hand vacuum for
Operation
The following steps must be performed before
commencing work:
► Ensure that the following components are in
safe condition:
– Hand vacuum,
– Battery, 4.6.2.
– Charger, 4.6.3.
► Check the battery,
► Fully charge the battery,
► Cleaning the hand vacuum,
► Check the controls,
► If you cannot carry out these steps: Do not use
the hand vacuum and contact your STIHL
dealer for assistance.
6

Charging the Battery, LEDs

6.1 Mounting the Charger on a
Wall
The charger can be mounted on a wall.
0458-006-9821-B
4.6.1.
10.2.
6.2.
15.1
10.1.
1 2
a
b
a
Check the following points
►
when mounting the charger on
a wall:
– Suitable fixing materials.
– The charger is level.
The following dimensions are observed:
– a = at least 100 mm
– b = 54 mm
– c = 4.5 mm
– d = 9 mm
– e = 2.5 mm
6.2 Charging the battery
The charging time depends on various factors,
e.g. the battery temperature or the ambient tem‐
perature. For optimum performance, observe the
recommended temperature ranges,
actual charging time may vary from the charging
time indicated. The charging time is indicated at
www.stihl.com/charging-times.
The charging process starts
automatically when the mains
plug is plugged into a socket
and the battery is inserted into
the charger. The charger
switches off automatically when
the battery is fully charged.
The battery and the charger warm up during
charging.
1
3
English
3
d
e
e
18.6. The
2
5 6
4
27