Fax: +90 232 210 32; Specifications - Stihl SEA 20.0 Instruction Manual

18 Specifications

Fault LEDs on the
hand vacuum
Hand vacuum
runtime is too
short.
17.2 Troubleshooting the Charger
Fault LED on Char‐
ger
Battery not being One LED glows
charged. red.
The LED fla‐
shes red.
The charger The LED
does not run a glows green for
self test. about 1 second
and then red
for about
1 second.
18 Specifications
18.1 STIHL hand vacuum SEA 20.0
– Approved battery: STIHL AS
– Weight without battery: 1.1 kg
– Maximum air throughput: 1026 l/min
– Maximum vacuum: 80 mbar
sample inspection
– Length: 465 mm
– Width: 113 mm
– Height: 187 mm
– Inside diameter suction hose: 29 mm
– Maximum container capacity: 0.75 l
Consult www.stihl.com/battery-life for the respec‐
tive running time.
18.2 STIHL AS Battery
– Battery Technology: Lithium-ion
– Voltage: 10.8 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
– Weight in kg: see rating label
0458-006-9821-B
Cause
The battery is not fully
charged.
The battery service
life has been excee‐
ded.
Cause
The battery is too
warm or too cold.
No electrical contact
between charger and
battery.
There is a malfunction
in the charger.
There is a fault in the
battery.
Electrical contact to
charger was briefly
interrupted.
18.3
– Rated voltage: see rating pate
– Frequency: see rating plate
– Rated power: see rating plate
– Charging current: see rating plate
– Maximum energy content of approved STIHL
AS battery: 12.5 Ah
For charging times see www.stihl.com/charging-
times.
18.4
If an extension cord is used, the cross sectional
area of its conductors must meet the following
minimum requirements – depending on the line
voltage and length of the extension cord:
If rated voltage on the rating label is 220V to
240V:
– Cord length up to 20 m: AWG 15 / 1.5 mm²
– Cord length 20 m up to 50 m: AWG 13 /
2.5 mm²
Remedy
► Empty the container.
► Clean the hand vacuum.
► Fully charge the battery.
► Replace battery.
Remedy
► Leave battery inserted in charger.
Charging starts automatically as soon as
the permitted temperature range is rea‐
ched.
► Remove the battery.
► Clean contacts on charger.
► Insert battery.
► Do not use the charger and contact your
STIHL dealer for assistance.
► Do not use the battery. Consult a STIHL
dealer.
► Disconnect the mains plug from the
power supply.
► Wait for 1 minute.
► Insert the mains plug in a wall outlet.
STIHL AL 1 Charger
Extension Cords
English
33