Advertisement

Viking XS and Viking S are two flexible mobile lift models
which are excellent in environments with limited space.
The application areas are the most commonly used lifting
situations, such as transfer between bed and wheel chair,
to and from the toilet and lifting to and from the floor.
Viking XS and Viking S have electric raising and lowering
of the lift arm and mechanical base widening.
Viking S has three height settings on the lift mast in order
to give an optimal lifting interval for different needs.
In this document, the person being lifted is referred to as the patient, and the person helping them is referred to as
the caregiver.
is a warning triangle used for situations which require extra care and attention.
IMPORTANT!
Read the instruction guide for both the patient lift and lifting accessories before use. Lifting and transferring
a person always involves a certain level of risk. It is important to completely understand the contents
of the instruction guides. The equipment should only be used by trained personnel. Please contact
your Liko/Hill-Rom representative in the event of any uncertainties or questions.
Product Description
The middle position is the standard setting; the lowest
is suitable for, for instance, lifting children to and from
the floor. Select the highest position for lifting extra
high, for instance to beds/gurneys with fixed heights.
Individual fitting of the sling and other lifting accessories
is of utmost importance for function and safety when
using the lift.
Viking™ XS / Viking™ S
Viking S
Viking XS
Instruction Guide
English
7EN138104-01
2011-05-24
Applies to the following models:
Prod. No. 2040006
Prod. No. 2040007

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Liko Viking XS and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Hill-Rom Liko Viking XS

  • Page 1 It is important to completely understand the contents of the instruction guides. The equipment should only be used by trained personnel. Please contact your Liko/Hill-Rom representative in the event of any uncertainties or questions.
  • Page 2: Table Of Contents

    Viking S/Viking XS complies with the requirements in EN ISO 10535:2006, IEC 60601-1, IEC 60601-1-2, ANSI/AAMI ES60601-1, and CAN/CSA C22.2 no 60601-1. Under no circumstances must the lift be modified. If you have any questions, please contact Liko/Hill-Rom. Particular care must be observed when using strong sources of potential disturbance, such as diathermy, etc, so that diathermy cables are not positioned on or near the lift.
  • Page 3: Definitions

    Definitions 1. Lift arm 2. Flexlink 3. Sling bar with latches 4. OuterTube 5. Lift motor 6. Product decal 7. Front wheels 8. Base 9. Rear wheel with brake 10. Lever for base width adjustment Forward direction 11. Locking handles 12.
  • Page 4: Measurements

    Measurements Lateral view Top view Max. reach of lift arm max. min. Max. reach of lift arm Table of measurement: Viking S (mm.) A* max A* min B3** D2** max. min. max. min. max. min. max. min. 1970 1310 1260 910 1130 645 1010 520 245 1100 1000 110 1750 450 (inch.)
  • Page 5: Assembly

    Assembly Before assembly, make sure you have the following parts: • lift mast with lift arm, motor for lift arm, • locking handles (1 pair) sling bar and control unit • bag containing instruction guide, quick reference • base, lever for base width adjustment guide and adapter for battery charger •...
  • Page 6: Operation

    Reset the emergency stop by turning the red button 5. Before the first use, the lift’s battery should in the direction of the arrows. be charged for at least 12 hours. For detailed instructions, see ”Charging the Batteries”, p. 8. After assembly, make sure that: •...
  • Page 7 Electrical Emergency Lowering Mechanical Emergency Lowering Lower the lift arm by pressing the marking Turn the red emergency lowering cylinder for ”down” ( ) on the control unit. in the direction of the arrows. Unlock Lock Emergency Stop Locking the Wheels To activate the emergency stop: Press the red The rear wheels can be locked to prevent rotating and button.
  • Page 8: Charging The Batteries

    Viking S and Viking XS comply with the Directive 2002/96/EC on waste electrical and electronic equipment. Old batteries are to be deposited at the nearest recycling facility in accordance with local regulations or given to personnel authorized by Liko/Hill-Rom. www. li k o.com...
  • Page 9: Maximum Load

    300 kg (660 lbs). In this case, the maximum load of 160 kg (350 lbs) applies to the assembled lift unit. Check the markings on the lift and lifting accessory or contact your Liko/Hill-Rom representative if you have any questions.
  • Page 10 Viking, we recommend LikoScale 350 (adapter 2016504 required). LikoScale 350 is approved in accordance with European Directive NAWI 90/384 (Non-Automatic Weighing Instruments). Contact your local Liko/Hill-Rom representative Adapter 12 mm LikoScale 350 for more information. Prod. No. 2016504 Prod. No. 3156228 Leg Protector Viking S Prod.
  • Page 11: Simple Troubleshooting

    3. Make sure that the control unit cables are connected correctly. 4. Check that the charging cable is not connected to a wall socket. If the problem remains, please contact Liko/Hill-Rom. The charging of the lift’s battery 1. Check that the emergency stop button is not doesn’t work activated.
  • Page 12: Inspection And Maintenance

    For instructions on how to recycle your Liko product, please visit our website: www.liko.com. Product Changes Liko’s products undergo continuous development, which is why we reserve the right to make product changes without prior notice. Contact your Liko/Hill-Rom representative for advice and information about product upgrades. Design and Quality by Liko in Sweden Liko is quality-certified in accordance with ISO 9001 and its equivalent for the medical device industry, ISO 13485.

This manual is also suitable for:

Liko viking s

Table of Contents