Maintenance/Remote Battery Replacement; Vacation And Long-Term Storage - Bruno ELITE CRE-2110E Operator's Manual

Rear of transmitter
Rear of transmitter
with 1 rear cover
removed
9V battery
MAINTENANCE TIPS
Remote Battery Replacement
• Detach transmitter from the wall.
• Remove the rear cover.
• Remove old battery and replace with new 9v battery
(replace annually).
• Remount transmitter on the wall.
General Maintenance Tips
• Keep the rail channel clean and free of debris.
• Park the stairlift at one end of the rail when not in use
to keep batteries charged.
• Keep battery charger plugged into a live outlet.
• Contact your Bruno dealer annually to have the
stairlift examined, cleaned and lubricated.
Note: Scratches to paint during handling, installation
or normal use should be retouched using paint available
through your Bruno dealer. Inspect painted surfaces for
scratches upon receipt, after installation, and once a year.
Failure to touch up scratches that cause limited rusting may
void the warranty.

Vacation and Long-Term Storage

• Turn off the circuit breaker (ON/OFF switch near the seat).
• Remove all keys (remotes and armrest keyswitch) and
store in safe location.
• Remove batteries from and store according to battery
manufacturer's instruction.
• Unplug battery charger from wall outlet and store indoors.
• Place cover over the stairlift and tighten the drawstring.
Once you are ready for the stairlift to return to action, take
the following steps:
• Have batteries reinstalled in the CRE-2110 E.
• Loosen seat cover drawstring and remove cover.
• Clean, dirt and moisture from the seat and carriage.
• Have fresh coat of grease applied to gear rack.
• Insert keys in the armrest keyswitch and remotes.
• Turn on the circuit breaker (ON/OFF switch near the seat).
• Reconnect the battery charger to an AC outlet.
• Run the stairlift up and down the rail several times to
verify correct operation.
Note: Batteries may require recharging before normal use
if the stairlift was unused for an extended period of time. To
recharge, turn on the circuit breaker, reconnect the charger
to the wall outlet and wait until the charger LED light turns
green to indicate the batteries are fully charged.
9
CRE-2110E OPERATOR 01-28-2022