Standard Swivel Seat - Bruno ELITE CRE-2110E Operator's Manual

Standard Swivel Seat

Swivel Positions: The Elite Curve seat, with standard
armrests, swivels a total of 135 degrees. The seat locks in
three positions: the center "home" position and 60 and 90
degrees at the top landing. (Some installations allow the
chair to swivel 45 degrees to the bottom
How to Rotate Seat: Swivel the seat at the top landing to
safely exit away from the steps. Lift the release handle
located under the seat (on either side of the chair). Once the
swivel lever is released, the seat will lock in the closest 60-
or 90-degree position
Flip-Up Seat: Save space on your stairs when your stairlift is
not in use by flipping up the seat and armrests.
Mid-Park Position Option
The mid-park position option allows you to park and charge the stairlift at a position between
two ends of the rail.
• Turn the armrest control key ON
• Press the armrest control switch to move the stairlift up/down the rail
OR
• Turn the key ON the remote -control box
• Press the remote control UP/DOWN to move the stairlift
The stairlift will always stop and beep once it reaches the mid-park position.
• Resume travel to the top/bottom of stairs.
• Release armrest control switch or remote button when you arrive at top or bottom landing.
The stairlift seat will again stop and beep to indicate the end of travel.
CIRCUIT BREAKER
Note: The stairlift includes an ON/OFF switch with a built-
in circuit breaker that protects the battery, controller and
motor circuits in the stairlift carriage. It is unlikely the
circuit breaker will trip. However, if the stairlift becomes
inoperative, check the circuit breaker and reset if needed.
Possible causes of circuit breaker tripping:
• Foreign object jamming the rail or gear rack.
• Exceeding the rated weight capacity of the stairlift.
CRE-2110E OPERATOR 01-28-2022
OPERATION
landing.)
6
Swivel release
handle
ON/OFF switch
with built-in
circuit breaker