Do you have a question about the ELECTRA-RIDE SRE-1540 and is the answer not in the manual?
Questions and answers
Gerald J DRISCOLL
January 24, 2025
Would not run
1 comments:
Mr. Anderson
February 10, 2025
The Bruno ELECTRA-RIDE SRE-1540 may not run due to several possible reasons:
1. Power Issues – The unit operates on two 12-volt batteries. If the batteries are discharged or the charger is unplugged, the stairlift may not function. Ensure the circuit breaker is turned on and the charger is properly connected.
2. Safety Device Activation – If a safety device is triggered, the unit will stop. Check for any obstructions blocking the sensors or ensure the seat safety switch is engaged.
3. Elevator Stopped Off Charge Bumper – If the stairlift is stopped off the charging station, it will beep periodically. Move it back to the charging bumper to restore functionality.
4. Battery Voltage Issues – If the battery voltage drops too low or becomes critically low, the stairlift may not operate. Recharge the batteries by reconnecting the charger.
5. Circuit Breaker Off – If the unit has been in long-term storage, the circuit breaker might be off. Turn it on before using the stairlift.
Check these factors to determine why the stairlift is not running.
Summary of Contents for Bruno ELECTRA-RIDE SRE-1540
Page 1
1780 EXECUTIVE DR., P.O., BOX 84, OCONOMOWOC, WI 53066 USA TEL.: (262) 567-4990 FAX: (262) 953-5501 Toll free number valid throughout the U.S. and Canada Bruno invites your calls at: 1-800-882-8183 Technical Service email: service@bruno.com Technical Service fax: 262-953-5503 SAFETY AND OPERATING...
TROUBLESHOOTING BEFORE CALLING YOUR BRUNO DEALER - PLEASE REFER TO THE CHECKLIST BELOW. YOU MAY PREVENT AN UNNECESSARY SER- VICE CALL! Check swivel seat. Is seat locked in riding position? Check footrest. Is there an obstruction on the stairway? Check carriage safety panels.
TWO YEAR LIMITED WARRANTY for Bruno Stairlifts Bruno Independent Living Aids, Inc. (“Bruno”), warrants to the original purchaser of a Bruno Stairlift that the Bruno Stairlift is free from defects in material and workmanship for a period of two years from date of purchase.
Page 20
Bruno, damage in shipment, or repairs undertaken by anyone other than Bruno factory employees or authorized distributors. The “original purchaser” of a Bruno Stairlift that is leased or rented shall be the person or entity acting as the lessee or rental provider.
Need help?
Do you have a question about the ELECTRA-RIDE SRE-1540 and is the answer not in the manual?
Questions and answers
Would not run
The Bruno ELECTRA-RIDE SRE-1540 may not run due to several possible reasons:
1. Power Issues – The unit operates on two 12-volt batteries. If the batteries are discharged or the charger is unplugged, the stairlift may not function. Ensure the circuit breaker is turned on and the charger is properly connected.
2. Safety Device Activation – If a safety device is triggered, the unit will stop. Check for any obstructions blocking the sensors or ensure the seat safety switch is engaged.
3. Elevator Stopped Off Charge Bumper – If the stairlift is stopped off the charging station, it will beep periodically. Move it back to the charging bumper to restore functionality.
4. Battery Voltage Issues – If the battery voltage drops too low or becomes critically low, the stairlift may not operate. Recharge the batteries by reconnecting the charger.
5. Circuit Breaker Off – If the unit has been in long-term storage, the circuit breaker might be off. Turn it on before using the stairlift.
Check these factors to determine why the stairlift is not running.
This answer is automatically generated