Charging And Diagnostic Codes - Bruno ELITE CRE-2110E Operator's Manual

CHARGING and DIAGNOSTIC CODES (under the seat)
LED
Glowing LED = charging
Keeping Stairlift Charged
Bruno's curved stairlift are powered by two 12v batter-
ies that charge when the lift is parked tightly against the
brackets at either end of the rail. If the stairlift carriage
does not contact the upper or lower charge brackets, the
batteries will slowly drain.
Failure to keep the batteries charged, or allowing them
to fully discharge, will significantly shorten battery life.
Therefore, it is important to park the stairlift at either end
of the rail.
A yellow LED light glows on the upper and lower charge
brackets if the stairlift is correctly parked and charging.
If you cannot park at one end of the stairs (for example,
a door prevents it), use the remote control to "send" the
stairlift to the end of the rail to stay in contact with the
charge bracket. Then, use the remote to "call" the stairlift
when you need it.
Diagnostic Codes - Under the seat
C1 Charging
C2 Off Charge
C3 Off Charge and Not Parked
C4 Parked and Charger Not Detected
C5 Battery Voltage Critical
C6 Battery Voltage Low
L1 Seat Safety Switch Open
L2 Up Limit Switch Open
L3 Down Limit Switch Open
L6 Mid-Rail Park Active
L8 Soft Stop Switch
7
CRE-2110E OPERATOR 01-28-2022