The Pincode System - Bang & Olufsen BeoVision 7 Manual

22
The pincode system is intended to
make normal use of your television
impossible for someone who does
not know the pincode. You choose
whether or not to activate the
pincode system.
When the pincode system is activated
and the television has been
disconnected from the mains for 15–30
minutes, the pincode system goes
into effect.
When reconnected and switched on,
the television automatically switches
itself off after four minutes. Entering
the pincode returns the television to
normal.
Downloaded from ManualsNet.com

The pincode system

Activate the pincode system
Bring up the TV SETUP menu on the screen,
activate the PINCODE menu and choose from
the submenus.
If you wish to deactivate the pincode system,
you can do so by deleting you pincode.
PROGRAM GROUPS
TUNING
TIMER RECORDING
PLAY TIMER
OPTIONS
STAND POSITIONS
GROUP1
. . .
. . .
back
PROGRAM GROUPS
TUNING
TIMER RECORDING
PLAY TIMER
OPTIONS
STAND POSITIONS
GROUP1
. . .
. . .
back
NOTE! You can change your pincode up to fi ve
times within a three-hour period.
search engine
TV SETUP
PINCODE
PINCODE 0 . . .
CONFIRM PINCODE . . . .
next
select
GO
accept
GO
TV SETUP
PINCODE
DELETE PINCODE
NEW PINCODE
select
GO
select
GO
To activate the pincode system...
> Press MENU to bring up the TV SETUP menu.
> Press twice, followed by STOP. The PINCODE
menu appears on the screen.
> Use the number buttons or
enter the four digits of your code. Press
back to digits you wish to correct and use
to change them.
> Press GO after the last digit is found.
> Re-enter your code to confi rm it and press GO
again. If the two codes are not identical, the
input fi elds are cleared and you must enter the
code again.
To change or delete your pincode...
> Press MENU to bring up the TV SETUP menu.
> Press twice, followed by STOP. The PINCODE
menu appears on the screen.
> Enter the correct pincode and press GO.
DELETE PINCODE is highlighted.
> To delete your code, press GO.
> To change your code, press to highlight
NEW PINCODE and press GO. Enter the new
code using the number buttons or
press GO. Re-enter the new code to confi rm it.
If you inadvertently press a wrong button while
entering a code, press STOP. The entry is
cancelled and the input fields are cleared.
on Beo4 to
to go
or
and