Maintenance And Cleaning; Detergent Drawer; Inlet Water Filters - Smeg LAVATRICE LBS86F User Manual

Switching the machine to standby
mode
Press "Start/Pause/Cancel" button momentarily
to switch your machine to the standby mode.
Auxiliary functions can be cancelled or selected
in accordance with the step the program is at.
The door can be opened if the water level is
suitable. Laundry may be added / taken out by
opening the door.
Child-proof lock
This function protects the appliance from being
tampered by children. In this case, all of the
buttons are inactive except On/Off button; by
On/Off button you can whether stop or resume
(while child-lock on) the program of your
machine.
The machine is switched to child-lock by
pressing the 1st and 2nd auxiliary functions from
the left for 3 sec. Child-proof lock lamp on the
program follow-up indicator will light up when
the child-proof lock is activated. To deactivate
the child-proof lock, press the same buttons for
3 sec.
Ending the program through
canceling
In order to cancel the selected program, press
the "Start/Pause/Cancel" button for 3 seconds.
You can select and start a new program when
the "Ready" light is lit.
The "Spin" light illuminates if the cancellation
process is activated in the middle of the program
and the machine can either drain all the water or
can take in water 3 times at most to cool down
the clothes and perform the draining process.
The program which is selected first will keep
on going even if the position of the program
selection button is changed. A new program
can be selected or started after "Program is
cancelled" in order to change the washing
program.
End of program
The "Ready" lamp on the program follow-up
indicator will light up when the program comes
to an end. The door can be opened and the
machine is ready for a second cycle now. Press
the "On/Off" button to shut down the machine.

5 Maintenance and cleaning

Detergent Drawer

Remove any powder residue buildup in the
drawer. To do this;
1. Press the dotted point on the siphon in the
softener compartment and pull towards you
until the compartment is removed from the
machine.
C
If more than a normal amount of water
and softener mixture starts to gather in the
softener compartment, the siphon must be
cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water in a
washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its original
location.

Inlet water filters

There is a filter at the end of each water intake
valve at the back side of the machine and also
at the end of each water intake hose where they
are connected to the tap. These filters prevent
the foreign substances and dirt in the water to
enter into the machine. Filters should be cleaned
as they get dirty.
• Close the taps.
• Remove the nuts of the water intake hoses to
clean the surfaces of the filters on the water
intake valves with an appropriate brush.
• If the filters are very dirty, you can pull them
out by means of pliers and clean them.
• Take out the filters on the flat ends of the
water intake hoses together with the gaskets
and clean thoroughly under streaming water.
• Replace the gaskets and filters carefully to
their places and tighten the hose nuts by
hand.
9 - EN