Video Index Search System - Toshiba SD-22VB User Manual

Whenever a recording is begun an
invisible index mark is recorded on the
tape. These index marks are all identical,
and each mark means: "Here starts a
new recording". Every DVD/VCR
equipped with the Video Index Search
System (VISS) can locate these marks
at the beginning of any recording.
VCR DVD
AUDIO
TV/VCR AUX
AUDIO SELECT
MEMORY ZOOM E.A.M
TIMER REC
REC/OTR RETURN
PLAY
REW
SLOW
STOP
INDEX Ð SKIP INDEX +
TITLE
SET UP
MENU
CH +
VCR MENU
SET Ð SET +
ENTER
CH Ð VIDEO Plus+
CANCEL
Notes:
• When you record an INDEX mark at
the very beginning of the tape, the
mark may not be found.
•
During INDEX search, the tape may
stop and begin to play at a slightly
different location.
• INDEX may not function properly with
old or worn out video tapes.
•
INDEX marks may not be found if it is
extremely close to the point where the
search began.
• In recording, if you stop recording tem-
porarily, the INDEX mark is not re-
corded on the tape.
Example: Indexing of TV commercials.
1
2
OPEN/CLOSE
CLOCK
COUNTER
ANGLE
COUNTER RESET
SUBTITLE
Recording several Index Marks
ATR
Due to the system only one index mark will be recorded at the
PLAY MODE
beginning of a recording. If you intend to set several index marks
SP/LP
during a single recording, follow the procedure below:
DISPLAY
CALL
1
FWD
PAUSE/STILL
2
A-B RPT
ZERO RETURN
INSTANT SKIP
Index Search
Press INDEX + or – during stop or play
mode.
For Succeeding programs:
Press INDEX +.
For Preceding programs:
Press INDEX –.
(Additional press increases the INDEX
NO. up to 9.)
When the INDEX + or – is pressed, the
unit starts searching the INDEX NO.
selected and finds the portion, then
playback starts automatically.
To stop the Index Search, press STOP.

Video Index Search System

Start playback and wait until the
end of the TV commercial is
reached, then press STOP.
Press REC/OTR. When the "INDEX" on-screen indication goes
off, STOP may be pressed. This short recording process will be
sufficient to set an index mark.
This will result in about 10 seconds of the TV commercials to be
overwritten by another recording. Due to the system the end of
this recording will be followed by a recording gap (noise signal)
of approx. 5 seconds.
At the point of the recording where
an index mark is to be set press
PAUSE/STILL. The unit will switch
to the recording pause mode.
Press CH repeatedly to switch back
to the original TV program. Press
PAUSE/STILL to resume recording.
CH 2
INDEX
+3
or is displayed
INDEX NO. (up to 9)
23