Table of Contents
Advertisement
8.1.2 Daily inspection
Check up at parts recommended in the section 8.2(1) „Daily inspection", whether the
jacks are not damaged nor have no defect. Carry out this inspection also during
operation in the interval between regular inspections. Qualified employees will
determine, whether any defect or damage can constitute a hazard and whether the
detailed inspection is necessary.
8.1.3 Regular inspection
Carry out overall inspections of the jack in the form of recommended regular
inspections. The recommended regular inspection stated in the section 8.2(2) must
be performed under the supervision of the competent persons who will determine,
whether the jack is necessary to be taken to parts. These inspections comprise also
requirements of the daily inspection.
8.1.4 Jack occasionally used
(1) Submit the jack not being in operation for a period of one month or longer but less
than a year to inspection complying with requirements in the section 8.1.2 before
follow-up putting it into operation.
(2) Submit he jack not being in operation for a period of one year to inspection
complying with requirements in the section 8.1.3 before follow-up putting it into
operation.
8.1.5 Report on inspection
Keep the record of performed tests, inspections and maintenances of jacks every
time. Carry out dating reports on inspections in intervals specified in the section 8.1.1
(2)(b) and keep them in the place specified by the user.
The person responsible for safety and determined by the user must be advised of
defects detected by the inspection or recorded during the operation.
8.2 INSPECTION PROCEDURE
(1) Daily inspection (carried out by operating staff or person responsible)
Part
1. Jack function
2. Pawls function
3. Fixative parts
Inspection method
Visually,
aurally
Visual inspection
when jacking up
Visual inspection of
all screws, nuts,
rivets etc.
Limit / criteria for
putting-out of
operation
The jack goes
hardly, stammers,
emits noise etc.
Pawls do not snap
behind dents of the
ratchet.
Faulty or missing
parts;
Released parts
13
Remedy
To clean up and
grease the jack. If
the defect will not
be removed, get the
jack repaired.
To clean up,
grease, eventually
change the spring.
Replace by new
ones;
To retighten
released parts
Advertisement
Table of Contents
