Safety Work Environment; Check-Up On The Jack; Inspection; Inspections Types - Brano 15-00 Operation Manual

7.1.2 By reason that the work with heavy loads can constitute unexpected hazard it is
necessary to follow all „Security principles" according to the chapter 3 of this
OM.

7.2 SAFETY WORK ENVIRONMENT

! Warning
(1) The operating personnel must be demonstrably acquainted with this Operation
Manual; they must adhere to valid security and hygienic regulations and must be
qualified for operation of this equipment.
(2) When working with the jack the operation staff must be equipped with gloves and
appropriate footwear.
(3) When operating by more persons always one worker must be determined who is
trained in safety at work and is responsible for jack handling.
(4) Before starting the work, the operation staff must check up whether all work area
is safety and whether there is the possibility of eventual escape from the
environment of jeopardy.
(5) With a product load capacity of 2,5t and 5t, the cover with the product casing is
not sufficiently dimensioned in terms of "breakthrough", therefore any cover that
could cause a collision with gears must be repaired or replaced. If the product
collides with a falling, flying (object (rock slide...) that could sufficiently damage
the covers, work must be stopped immediately and the product inspected.

8 CHECK-UP ON THE JACK

8.1 INSPECTION

8.1.1 Inspections types

(1) Introductory inspection: it precedes first use. The responsible competent person
must check up all new or repaired jacks to ensure the qualified fulfillment of
requirements of this OM.
(2) The jack inspections carried out regularly are generally divided to two groups
according to inspections intervals. Intervals depend on the state of critical parts
of the jack and rate of wear, damage or malfunction. Two main groups are here
marked as daily and regular ones. The appropriate intervals are defined as
follows:
(a) Daily inspection: visual check up carried out by the operation staff determined
by the user that is made at the beginning of each use.
(b) Regular inspection: visual check up carried out by the competent person
determined by the user.
1) Current operation – once a year,
2) Heavy operation – every six month,
3) Special or occasional operation – according to recommendations of the
competent person at first use and according to the order of qualified employees
(maintenance workers).
12