Advertisement
107P2 CM 25 GSIII
14
Go to cover page
7) When the horizontal moire is adjusted, press the
VERTICAL.
8) To adjust the vertical moire, press the
9) When the vertical moire is adjusted, press the
the EXTRA CONTROLS window. BACK TO MAIN CONTROLS will be
highlighted.
Smart Help
After returning to MAIN CONTROLS . . .
. . . to exit completely, press the
CLOSE MAIN CONTROLS
Back
OSD Adjustments (Continued)
button to highlight
or
button.
button to return to
button.
To lock (disable) OSD function:
- Press OSD button "
" for over 15 seconds to lock the OSD function.
Release it, then OSD comes on the screen as below.
ATTENTION
CONTROL MENU IS LOCKED
To unlock (enable) OSD function:
- Press OSD button "
" for over 15 seconds again to unlock the
OSD function.
Release it, then OSD comes on the screen as below.
Disable the WARNING SIGNAL &
Access Service mode (burn in mode) :
The WARNING SIGNAL of
NO SIGNAL INPUT
-After disconnect the Interface cable of the monitor,then Monitor is powered ON.
- If it is successful, the signal "
NO SIGNAL INPUT
To disable all the WARNING SIGNAL :
- Connect the Interface cable of the monitor (Monitor is ON.).
- If it is successful, then the signal "
Access Service Mode & Burn in mode
Firstly, get into Factory Adjustment Mode.
Push LEFT
& RIGHT
over 15 seconds and release them.
The factory message appears at the bottom of the
main OSD menu. (for example :107PVE V1.44 000427
M.T.B.F. in HOUR unit)
00195 is
- Disconnect the Interface cable of the monitor.
-
Push LEFT
& RIGHT
buttons at the same time,then power ON.
- If it is successful, the signal "
comes on the screen later.
(Background is white.).
- In the beginning of service mode
(full white pattern), the monitor
will working at 48kHz of horizontal
frequency,after 55 seconds, it will
switch to 81kHz automatically,
then change mode between
two modes constantly every 55 seconds.
-Leave "
burn in
MODE" :
.
Reconnect the interface cable to PC,
then the "
burn in
MODE" disappear.
appeared
:
" comes on the
screen again later.
"disappeared.
NO SIGNAL INPUT
buttons at the same time for
;
00195
107PVE V1.44 000427
"
SERVICE MODE
SERIAL NO: TY 123456
HOURS : 00021
FACTORY VER 1.01 990706
Forward
Advertisement
