Advertisement
4.11 White color adjustment
Based on the 1931 CIE chromaticity (colour triangle)
diagram (x,y coordinatio n).
coordination of white display on screen center should be:
for 9300 degreeK
for 6500 de greeK
for 5500 degreeK
Check conditions :
Set brightness control at 50% position and contrast at maximum.
4.12 Color tracking on full white pattern
Ref. to white balance alignment result and set brightness at 50%, adjust
contrast control from 5FL to max. position, the colour coordinate
should not deviate more than following tolerance when
compare to display center:
X= X nominal +/ - 0.015
Y= Y nominal +/ - 0.015
4.13 Purity
Test patterns : Full White / Red / Green / Blue.
Conditions:As stated in item 4.0, the purity must be
4.14 Moire
Condition: Displaying a full white pattern , at any pre-set
M oire area should be less than 1/3 area @15FL via moire control.
However the OSD moire data of V -moire should have a default value
(mode dependent) for product outgoing .Increasing the moire control value
will have side effect on resolution (degrade focus),and phenomenon of flicker
and sawtooth.
5.0
Mechanical characteristics
5.1 User controls (all at front) Right to left
- Power ON/OFF
- OSD Menu
- Up
(Brightness)
- Down (Brightness)
- Right (Contrast)
- Left
(Contrast)
TYPE
BRAND : PHILIPS
00-06-07
K.C. Huang
Back
GENERAL PRODUCT SPECIFICATION
X = 0.283
+/ - 0.015
Y = 0.297
+/ - 0.015
X = 0.313
+/- 0.015
Y = 0.329
+/ - 0.015
X = 0.332
+/ - 0.015
Y = 0.347
+/ - 0.015
checked under specific destinations of earth
magnetic environments and the monitor to be
well degaussed.
After warming -up time of 30 min., no coloured stains may
occur in above four patterns.
mode the display size of the set s to be set
as stated in "Fig. 1".
CM25-17" 107P2 92KHz AR CRT
: 107P20/00H
00-06-07
8639 000 10649
13
23
590
107P2 CM 25 GSIII
57
Go to cover page
Forward
Advertisement
