Step 8 - Turn On The Qs Rc Transmitter; Step 9 - Check The Uav For Damages; Step 10 - Magnetometer Calibration (If Required) - Quantum TRINITY F90+ User Manual

8.8 Step 8 – Turn on the QS RC transmitter
1. Turn on the main switch
2. Check the battery status
mitter is below 50 %.
3. If the LED on the transmitter is off, the RC connection is successful.
A safety pilot who is able to control the UAV with the help of the transmitter is always required. Be prepared
to take over and control the UAV manually in assisted flight in case of an emergency. The transmitter must be
held by the pilot during the whole flight time.
8.9 Step 9 – Check the UAV for damages
Please make sure every part is free of damages.
8.10 Step 10 – Magnetometer calibration (if required)
Obligatory: flight location > 50 km away from the last flight location
Calibration and take-off area is free of metal (parking decks, cars, metal structures) or any devices causing electric or magnetic
fields (power lines, generators, mobile phones).
of the QS RC Transmitter.
of the transmitter. Do not fly if the battery capacity of the trans-
Flight setup – step by step
3
8
Trinity F90+ user manual 89