Emergency Stopping - Jayco SENECA PRESTIGE 2023 Owner's Manual

Table of Contents

Advertisement

Panel Indicator LED
If the LOW VOLTAGE, ENGAGE PARK BRAKE, IGNITION ON or
EXCESS SLOPE LEDs illuminate, you have an "error" condition that
must be corrected prior to operating the jacks.
Make sure suspension air bags have deployed after retracting jacks. Visu-
ally check front and rear wheel wells for clearance.
There are a total of ten (10) LED indicators on the Equalizer Keypad.
™ NOTE: During typical operation, the LEDs on the bottom left hand corner
of the keypad should NOT be illuminated. The only LED that should light is
the "OPERATING" LED, which should flash during operation.
POWER LED
JACK LED (4 each)
LOW VOLTAGE LED
ENGAGE PARK BRAKE LED
IGNITION ON LED
EXCESS SLOPE LED
For complete instructions, troubleshooting and safety information refer to the manufac-
turer's manual online at
installation-manuals/

Emergency Stopping

Always carry road flares or reflective warning signs. Pull off the roadway as far as possible
for emergency stopping. Turn ON your vehicle hazard warning flashers. If traveling at
night, use three red warning indicators such as flares, reflectors or lanterns as required by the
Uniform Vehicle Code and Model Traffic Ordinance as follows:
Place the first warning indicator on the traffic side of the recreation vehicle, directed at
1.
the nearest approaching traffic.
2.
Place the second warning indicator 100 feet behind the recreation vehicle in the center
of the lane and toward approaching traffic.
3.
Place the third warning indicator 100 feet in front of the recreation vehicle in the center
of the lane and away from the traffic approaching from behind.
™ NOTE: Curves and/or hills may affect the safe placement of warning indica-
tors.
ON Red when power is ON
OFF when power is OFF
FLASH every 5 sec. in Sleep Mode
ON Red when Jack(s) are deployed
OFF when jack(s) are stowed
OPERATING LED FLASHING Red w/Auto
Level or All Retract
OFF when keypad is idle or "sleeping"
ON Red when voltage is below 10.5 volts dc
OFF when voltage is above 10.5 volts dc
ON Red when park brake is not set
OFF when park brake is set
ON Red when ignition is in the ON position
OFF when ignition is OFF
ON Red following an Auto Level attempt, if
system cannot overcome slope
OFF when slope is not excessive
https://equalizersystems.com/service-and-support/operation-and-
Table of Contents
Section 4: Vehicle Operation
37

Advertisement

Table of Contents
loading

Table of Contents