Indicator Lamp In The Charging Station - Flymo EasiLife Operator's Manual

6.4 Indicator lamp in the charging station

The indicator lamp in the charging station must show a solid or flashing green light for a correct installation. If not,
follow the instructions in the troubleshooting table below.
Speak to your Flymo service for more information.
Light Cause
Green solid light Good signals.
Green flashing light The signals are good and
bled.
Blue flashing light The boundary wire is not connected to the
charging station.
Damage in the boundary wire.
Yellow flashing light The guide wire is not connected to the charg-
ing station.
Damage in the guide wire.
Red flashing light Interference in the antenna of the charging
station.
Red solid light Error in the circuit board or incorrect power
supply in the charging station. The error must
be corrected by your Flymo service
40 - Troubleshooting
Action
Usual operation of the product.
ECO mode is ena-
Usual operation of the product. Refer to
mode on page 26 .
Make sure that the boundary wire is correctly
installed in the charging station. Refer to
install the boundary wire on page 19 .
Find out where the damage is. Replace the
damaged section with new boundary wire.
Make sure that the guide wire is correctly
installed in the charging station. Refer to
install the guide wire on page 19
Find out where the damage is. Replace the
damaged section with new guide wire.
Speak to your Flymo service.
Speak to your Flymo service.
ECO
To
To
1392 - 007 -