To Install The Main Unit On The Wall - Sharp HT-X1 Operation Manual

To install the main unit on the wall

HT-X1
Preparation:
Remove the stand from the main unit (perform steps 1 - 2 on page
18).
Sharp has designed the
main unit so you can hang
it on the wall.
Use appropriate screws
(not supplied). See the il-
lustration on the right for
size and type.
1
Drive two screws into the wall for main unit, as shown in
the illustration.
Make sure that both the screw and the wall can support a load
of 4.9 lbs. (2.2 kg).
Drive the screws, so the screw head extends about 7/32" (5.5
mm) out from the wall.
Wall surface
2
Fix the pattern paper and drive two screws into the wall
with a distance of 5-3/25" (130 mm) in between.
5 " ( 1 3
5 - 3 / 2
62
1/8" (3.2 mm)
3/16" (5 mm)
Min. 7/8" (22 mm)
3/8" (9 mm)
7/32" (5.5 mm)
Wall mounting screw
Min. 21/32" (16.5 mm)
)
0 m m
Pattern paper
for main unit
3
Tighten the screws and remove the paper. Hook the main
unit on the screw heads and make sure it is secure.
CAUTION:
! Make sure to prevent the main unit [4.9 lbs. (2.2 kg)] from falling
when mounting it on the wall.
! Before mounting, check the wall strength. (Do not put on a
veneer plaster or whitewashed wall. The main unit may fall.) If it
is not clear, consult with a qualified service technician.
! Mounting screws are not supplied. Use appropriate ones.
! Check all mounting screws for looseness and that they are
engaged in the main unit.
! Mount the main unit on the wall with 2 screws.
! Select a good location. If not, accidents may occur or the main
unit may get damaged.
! Avoid placing on a bed, sofa, water tank, sink and hallway wall.
! SHARP is not responsible for accidents resulting from improper
installation.