Data Transfer Test - Ebyte NA111 User Manual

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd.

2.3.3 Data transfer test

After the above steps, follow the device factory default parameters, do the following, to achieve

data transmission testing.

Here's how:

（1） Open the test TCP/IP debugging assistant software.

（2） The network settings area selects the TCP client mode, which corresponds to the server

IP address (module default target IP: 192.168.3.3). The server port number corresponds to the

module setting port 8887 (module default port: 8887), click Create.

（3） Wait for the computer to connect to the serial server, the connection is complete after the

serial server M0 (green LED lit).

（4） Open serial assistant, serial port rate is set to 115200, serial parameters are set to

None/8/1, click on open, open serial port.

Figure 2- 3 Gate parameter configuration

NA111 User Manual

Table of Contents