Configuration; About Configuration; About Basic And Advanced Operation; Set The Operation Mode At Initial Startup - Hach MET ONE 3400 User Manual

Icon Function
Test wizard Test and report wizard for ISO, EU-GMP, FS or BS classification compliance. Refer to
Return

Configuration

About configuration

This section describes tasks that are usually done at the initial commissioning stage. Other tasks are
done as updates to the particle counter are needed.
Note: If user passwords are set, the user must be logged in as an administrator to configure the particle counter.

About Basic and Advanced operation

At startup, the user can set the operation mode to Basic or Advanced settings.
Use the Basic mode to:
• Do all particle measurement functions
• Save run data in the buffer
Use the Advanced mode to:
• Export dialogs
• Measure air velocity
• Set analog alarms
• Set standards wizards and reports
• Backup, restore and restart
• Copy a configuration
• Set the network protocol (serial, Ethernet, Wi-Fi)
• Manage areas and locations
• Manage user counts and security
• Set user-configurable particle sizes
• Filter data

Set the operation mode at initial startup

To set the operation mode:
1. Power on the instrument.
2. While the operation mode selection screen shows, do one of the actions that follow:
• Select BASIC or ADVANCED.
• Wait 10 seconds. The instrument will start in the selected operation mode.

Change the operation mode

Only permissions in the Advance Operation mode allow a user to change the operation mode. To
change operation mode from Advanced to Basic mode:
1. On the Counter Navigation screen, push SYSTEM.
2. Select the Custom tab.
Table 2 Screen icon descriptions (continued)
Description
Set up the Test and Report Wizard
Return to the previous screen or menu.
on page 34.
English 19