Flash Triggering - Cactus V6 IIs User Manual

34

11. Flash Triggering

To command the flash units in different
groups to f ire:
1. Set the V6 IIs transceivers to the
2. Set both the TX and RX to the same
3. Assign RX unit(s) to A, B, C, or D group
4. Connect the V6 IIs RX to portable flashes
5. On the TX, press
6. Test f ire a particular group by pressing
7 . Attach the TX to the camera's hot shoe.
All manuals and user guides at all-guides.com
correct mode (transmitter to "TX" ,
receiver to "RX") . This will
automatically power on the transceivers
(see Section 9.4) .
channel (see Section 9. 5) .
and activate the group(s) on the TX (see
Section 9.6) .
or studio strobes.
status LED of both the TX and RX should
blink in green simultaneously. The
portable flashes or studio strobes will
f ire at the same time.
the group button and
simultaneously.
If your camera does not have a hot shoe,
connect the TX to the camera using an
completely. The
completely and