Lamp Replacement; Lamp Replacement Monitor Timer - Sanyo PLC-XP30 Owner's Manual

Sanyo owner's manual multimedia projector plc-xp30

Hide thumbs Also See for PLC-XP30:

User manual (76 pages)

Specifications (1 page)

Comparison chart (1 page)

Table Of Contents

Table of Contents

APPENDIX

When the life of the Lamp of this projector draws to an end, the LAMP REPLACEMENT indicator lights yellow.

When the image becomes dark or the color of the image becomes unnatural, replacement of the Lamp is

required.

CAUTION

For continued safety, replace with a lamp assembly of the same type.

Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector

can become very hot.

Do not drop the lamp assembly or touch the glass bulb! The glass can shatter and may cause injury.

Follow these steps to replace the lamp assembly.

Turn off the projector and disconnect the AC plug. Allow the

projector to cool for at least 45 minutes.

Remove the screw with a screwdriver and remove the Lamp

Cover.

Remove the two screws with a screwdriver and pull out the

Lamp Assembly by grasping the handle.

Replace the Lamp Assembly with a new one and tighten the two

screws. Make sure that the Lamp Assembly is set properly.

Replace the Lamp Cover and tighten the screw.

Connect the AC Power Cord to the projector and turn the

projector on.

Reset the Lamp Replacement Monitor Timer (refer to the section

"Lamp Replacement Monitor Timer" below).

NOTE : Do not reset the LAMP REPLACEMENT MONITOR

TIMER when the lamp is not replaced.

ORDER REPLACEMENT LAMP

Replacement Lamp can be ordered through your dealer. When ordering the Lamp, give the following

information to the dealer.

Model No. of your projector

Replacement Lamp Type No. : POA-LMP28

Be sure to reset the Lamp Replacement Monitor Timer when the Lamp Assembly is replaced. When the Lamp

Replacement Monitor Timer is reset, the LAMP REPLACEMENT indicator stops lighting.

Turn the projector on, and press the MENU button and the ON-SCREEN MENU will appear. Press the POINT

LEFT/RIGHT buttons to select SETTING and press the SELECT button (refer to the page 36, 37). Another dialog box

SETTING MENU will appear.

Press the POINT DOWN button and a red-arrow icon will appear. Move the arrow to "Lamp age," and then press the

SELECT button. The message "Lamp replace monitor Reset?" is displayed.

Select [Yes] to reset the Timer.

Do not reset the Lamp Replacement Monitor Timer, except after the lamp is replaced.