Basic Operation; Turning On / Off The Projector - Sanyo PLC-XP30 Owner's Manual

BASIC OPERATION

TURNING ON THE PROJECTOR
Complete the peripheral connections (with Computer, VCR, etc.)
1
before turning on the projector. (Refer to "CONNECTING TO
THE PROJECTOR" on Pages 11~14 for connecting that
equipment.)
2 Connect the projector's AC Power Cord into a wall outlet and
turn the MAIN ON / OFF SWITCH to ON. The LAMP indicator
lights RED, and the READY indicator lights GREEN.
Press the POWER ON-OFF button on the Remote Control Unit
3
or on the Top Control to ON. The LAMP indicator dims, and the
Cooling Fans start to operate. The Preparation Display appears
on the screen and the count-down starts. The signal from the
source appears after 30 seconds.
TURNING OFF THE PROJECTOR
Press the power ON-OFF button on the Remote Control Unit or
1
on the Top Control, and the message "Power off?" appears on
the screen.
Press the power ON-OFF button again to turn off the projector.
2
The LAMP indicator lights bright and the READY indicator turns
off. After the projector is turned off, the Cooling Fans operate
(for about 90 seconds). During this "Cooling Down" period, this
appliance cannot be turned on.
When the projector has cooled down, the READY indicator turns
3
to green again and you can turn the projector on. After cooling
down completely, turn the MAIN ON / OFF SWITCH to OFF and
disconnect the AC power cord.
TO MAINTAIN THE LIFE OF THE LAMP, ONCE YOU
TURN THE PROJECTOR ON, WAIT AT LEAST 5
MINUTES BEFORE TURNING IT OFF.
When the Power Management function is ON, the Projector detects the signal interruption and turns the Projection Lamp off
automatically. Refer to "Power Management" on page 33.
When WARNING TEMP. indicator flashes red, the projector is automatically turned off. Wait at least 5 minutes before
turning the projector on again.
When WARNING TEMP. indicator continues to flash, follow procedures below:
1. Turn the MAIN ON / OFF SWITCH to OFF and disconnect the AC power cord from the AC outlet.
2. Check the air filters for dust accumulation.
3. Clean the Air Filter. (See "AIR FILTER CARE AND CLEANING" section on page 39.)
4. Turn the Projector on again.
If WARNING TEMP. indicator should still continue to flash, contact the sales dealer where you purchased this projector or
service center.
NOTE: The Cooling Fan may work for cooling while the projector is turned off. When the Cooling Fan is
working, WARNING TEMP. INDICATOR flashes red.
20

TURNING ON / OFF THE PROJECTOR

30
The Preparation Display disappears after 30 seconds.
Power off?
The message disappears after 4 seconds.