Head Restraints - Alfa Romeo STELVIO 2022 Owner's Handbook Manual

WARNING
10) All adjustments must be carried out only
with the car stationary and engine off.
11) After releasing the adjustment lever,
always check that the seat is locked on the
guides by trying to move it back and forth.
If the seat is not locked into place, it may
unexpectedly slide and cause the driver to
lose control of the car.
12) Always make sure that all those on
board the car are seated and are wearing
their seat belts correctly.
13) Make sure the backrests are properly
secured at both sides to prevent them
from moving forward, in the event of sharp
braking, with possible impact with of the
passengers.
IMPORTANT
4) The fabric upholstery of the seats has
been designed to withstand long-term wear
deriving from normal use of the car. Some
precautions are however required. Avoid
prolonged and/or excessive rubbing against
clothing accessories such as metal buckles
and Velcro strips which, by applying a high
pressure on the fabric in a small area, could
cause it to break, thereby damaging the
upholstery.
5) Do not place any kind of items under
the electrically adjusted seats as they
could impede their movement or otherwise
damage the controls.
28

HEAD RESTRAINTS

ADJUSTMENTS
14)
Upward adjustment: raise the head
restraint until it clicks into place.
Downward adjustment: press button (1)
fig. 32 and lower the head restraint.
32
REAR HEAD RESTRAINTS
(adjustments)
Upward adjustment: raise the head
restraint until it clicks into place.
Downward adjustment: press button (1)
fig. 33 and lower the head restraint.
33
HEAD RESTRAINTS (removal)
Proceed as follows to remove the head
restraints:
raise the head restraints to their
maximum height;
press the button (1), lift the head
restraint, then, pressing the device (2)
04076V0001EM
fig. 32 (front head restraints) or (1) and (2)
fig. 33 (rear head restraints), remove it.
WARNING Always re-position the rear
head restraints if they had been removed
before starting to drive normally. Re-
fit the rods of the head restraints in
their housings, holding buttons (1) and
(2) pressed. Then, re-position the head
restraints according to your needs.
04076V0002EM