Alfa Romeo STELVIO 2022 Owner's Handbook Manual page 233

Oil level indication update on display
If a top-up is needed, proceed as follows
to ensure correct indication of the oil
level on the display:
2.9 V6 Engine
Proceed as follows:
with the car level, run the engine for
approximately 5 minutes (temperature
of approximately 198°F/ 90°C) and then
stop the engine;
wait for at least 5 minutes, turn the
ignition switch in ON position without
starting the engine and wait for a few
seconds.
If the level indication is not updated after
the previously described procedure,
repeat the engine adjustment, stop the
engine and wait a further 5 minutes
before starting it again. If the indication
is not updated after the second start,
contact the dedicated Alfa Romeo
Dealership.
WARNING In normal working conditions,
the oil level indication is shown on the
instrument panel display. In case of oil
level sensor failure (condition indicated
by the lighting of the symbol on the
instrument panel display), use the oil
dipstick in the engine compartment
EXCLUSIVELY for the time needed to
restore correct operation of the oil level
sensor. The latter operation must be
performed at a dedicated Alfa Romeo
Dealership.
2.2 JTD Engine
Proceed as follows:
with the car level, run the engine until
the third oil temperature notch lights on
the display on the instrument panel, then
stop the engine;
wait for at least 3 minutes, turn the
ignition switch to ON without starting the
engine and wait for 20 seconds.
Procedure for reading the engine oil level
with the engine running and idling
Proceed as follows:
with the car stopped, parked on level
ground, run the engine until the second
oil temperature notch lights on the
display on the instrument panel;
idle the engine and wait at least 1
minute for the correct reading.
2.0 T4 MAir engine
Proceed as follows:
with the car level, run the engine for
approximately 5 minutes (temperature
higher than 176°F (80°C)) and then stop
the engine;
start the engine again and idle it for
about 2 minutes.
WARNING If the indication is not correct
after the procedure, contact an Alfa
Romeo Dealership.
Engine oil consumption
80)
4)
The maximum engine oil consumption
is usually 0.88 lb (400 grams every
620 miles (1000 km). When the car is new,
the engine needs to be run in, therefore
the engine oil consumption can only be
considered stabilised after the first 3100
- 3700 miles (5000 - 6000 km).
ENGINE COOLANT
199)
81)
If the level is too low, unscrew the cap of
the reservoir and add the fluid described
in the "Technical Specifications" chapter.
WASHER FLUID FOR WINDSCREEN/
HEADLIGHTS
200) 201)
The windscreen and headlights washer
fluid reservoir (where provided) is
equipped with a telescopic filler.
If the level is too low, lift the reservoir
cap (4) fig. 261 upwards and then lift the
filler, as shown in the figure, and add
the fluid described in the "Technical
Specifications" chapter. After having
topped up the fluid, arrange the filler
correctly and then press on the cap until
you hear it click.
231