Head Restraints - Alfa Romeo Giulia Owner's Handbook Manual

Make sure that the armrest is properly
attached by trying to move it, if it is not
attached, repeat the operation.
WARNING
9) All adjustments must be made with the
car stationary.
10) After releasing the adjustment lever,
always check that the seat is locked on the
guides by trying to move it back and forth.
If the seat is not locked into place, it may
unexpectedly slide and cause the driver to
lose control of the car.
11) Always make sure that all those on board
the car are seated and are wearing their
seat belts correctly.
12) Make sure the backrests are properly
secured at both sides to prevent them
from moving forward, in the event of sharp
braking, with possible impact with of the
passengers.
IMPORTANT
4) The fabric upholstery of the seats has
been designed to withstand long-term wear
deriving from normal use of the car. Some
precautions are however required. Avoid
prolonged and/or excessive rubbing against
clothing accessories such as metal buckles
and Velcro strips which, by applying a high
pressure on the fabric in a small area, could
cause it to break, thereby damaging the
upholstery.
22
5) Do not place any kind of items under
the electrically adjusted seats as they
could impede their movement or otherwise
damage the controls.
6) Before tilting the backrest, remove any
objects on the seat cushion.

HEAD RESTRAINTS

ADJUSTMENTS
13)
They are height-adjustable: to adjust
them operate as follows.
Upward adjustment: raise the head
restraint until it clicks into place.
Downward adjustment: press button (1)
fig. 23 and lower the head restraint.
23
HEAD RESTRAINTS (removal)
Proceed as follows to remove the head
restraints:
raise the head restraints to their
maximum height;
press the button (1) and the device (2)
fig. 23 (front head restraints) or (1) and (2)
fig. 24 (rear head restraints) on the side
of the two supports, then remove the
head restraints pulling them upwards.
24
13) Head restraints must be adjusted so
that the head, rather than the neck, rests
on them. Only in this case they can protect
your head correctly. Any removed head
restraints must be repositioned correctly, in
04076S0001EM
order to protect the occupants in the event
of a collision: follow the instructions above.
04076S0002EM
WARNING