Nokia RH-29 Series Manual page 69

Nokia Customer Care
Set losses for the jig as shown in figure below:
Tuning
Connect the test jig MJ-21 to PC and to measurement equipment (if you are using R&S
CMU200, use RF2-port). Connect the engine board to jig, turn power on. Run Phoenix.
Select right connection type from Phoenix and set operating mode to local mode.
Select
Scan Product
Wait until phone information is shown in the lower right corner of the screen.
Check that there is right jig selected and losses set correctly, as described previously.
Start auto-tune
Select
Issue 1 05/2004
Company Confidential
Figure 18: Set loss for test jig
File
Tuning
Auto-Tune
Copyright © 2004 Nokia Corporation
Company Confidential
Alt-F
P
Alt-u
A
RH-29
6b - RF Troubleshooting
Page 41