Safety Instructions - IKEA SMAKLIG Manual

ENGLISH
If the glass ceramic surface / glass surface is cracked, switch
•
off the appliance and unplug it from the mains. In case the
appliance is connected to the mains directly using junction
box, remove the fuse to disconnect the appliance from
power supply. In either case contact the Authorised Service
Centre.
If the supply cord is damaged, it must be replaced by the
•
manufacturer, the Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
WARNING: Use only hob guards designed by the
•
manufacturer of the cooking appliance or indicated by the
manufacturer of the appliance in the instructions for use as
suitable or hob guards incorporated in the appliance. The
use of inappropriate guards can cause accidents.

Safety instructions

Installation
Warning! The appliance must be
installed by the authorised
installer.
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Follow the installation instructions
supplied with the appliance.
• Keep the minimum distance from other
appliances and units.
• Always take care when moving the
appliance as it is heavy. Always use safety
gloves and enclosed footwear.
• Seal the cut surfaces with a sealant to
prevent moisture from causing swelling.
• Protect the bottom of the appliance from
steam and moisture.
• Do not install the appliance next to a door
or under a window. This prevents hot
cookware from falling from the appliance
when the door or the window is opened.
• If the appliance is installed above drawers
make sure that the space, between the
bottom of the appliance and the upper
drawer is sufficient for air circulation.
• The bottom of the appliance can get hot.
Install a non-combustible separation
panel under the appliance to prevent
access to the bottom.
Refer to the Assembly Instructions.
• Make sure that the ventilation space of 2
mm, between the worktop and the front
of the below unit, is free. The warranty
does not cover damages caused by the
lack of an adequate ventilation space.
Transport and storage
• Products must be transported in the
original packaging in a horizontal
position.
• During transport and storage, protect the
product from weathering and mechanical
damage.
• Products should be stored in a packed
form in heated rooms at a temperature
from plus 5 °C to plus 40 °C.
28