Nakayama ET3500 Translation Of The Original Instructions page 14

Do not use the machine if damage or wear and
tear is visible.
Do not use electric machines near flammable
liquids or gases nor in wet or moist areas.
Failure to observe this warning can result in fire
or explosion.
Do not leave the machine running unattended.
Do not use the machine when tired or distracted
or when under the influence of alcohol or
medication.
Lack of attention can result in serious injury.
Work only with good light conditions.
You are responsible for safety in your working
area.
Keep the machine clean and functioning so
that you can work better and more safely.
Wear appropriate work clothes such as work
gloves, safety helmet, safety glasses or goggles
and long pants made of a strong material.
Stand with stable posture and wear non-slip,
high, closed footwear. Never work with the
machine wearing sandals or with bare feet.
Loose clothing, jewellery and long hair could
be caught in moving parts.
Wear a head covering over long hair.
Do not wear wide clothing or jewellery.
When working, maintain a stable and secure
posture. To prevent stumbling, avoid walking
backwards with the machine. Avoid abnormal
posture.
When working, always keep the machine at an
adequate distance from your body.
14
Always turn the machine off, wait for the motor
to stop and unplug the cord during work breaks
and when changing location.
Never leave the machine unattended at the
workplace. Store the machine during work
breaks in a safe location.
When changing work locations, always turn the
machine off.
Do not distract someone who is working with
the machine.
This could cause him/her to loose control of
the tool.
Be careful of people and animals within the
swinging range of the machine. Make sure that
they do not touch the power cord.
The operator is liable for damage and accidents.
Never use the machine in rain, moist or wet
areas and do not store it outside.
If the machine gets wet, wait until it is
completely dry before using it again.
Protect the machine from rain and moisture.
Work with the machine only in daylight or in
good artificial lighting.
Do not use any machine if the on/off switch is
faulty. A power tool with a non-functioning on/
off switch is dangerous and must be repaired.
Always turn the machine on before contact
with any materials.
The mains voltage must correspond with the
information on the type plate of the machine.
Do not carry the machine by the power cord.
Pull the cord out only by its plug. Protect the
cord from oil, heat and sharp edges. Damaged
cords could cause an electric shock.