Table of Contents
Advertisement
Operation
REMOVAL AND PLACING OF THE WASTE BAG
Stop the dust collector motors by flipping the three STOP switches.
1.
2.
Disconnect the plug from the power socket.
Use two ties to fasten the collection bag at two points about 1 – 2" (3 – 5 cm) from each other, just below the filter chamber.
3.
4.
Cut off the bag in the position between the two ties.
5.
Remove the lower part of the bag.
6.
Pull down a length of new bag from the chamber, until it reaches the bottom support plate
ATTENTION: USED BAGS SHOULD BE DISPOSED OF INTO A SPECIAL WASTE DISPOSAL CONTAINER, IN ACCORDANCE WITH LAWS
APPLICABLE IN THE COUNTRY WHERE THE DUST COLLECTOR IS USED.
24
406816_RevB
Advertisement
Table of Contents
