Signal Mode Column (Recommended) - Sanyo LCD-19E3 Instruction Manual

SIGNAL MODE COLUMN (recommended)

This LCD TV can correspond to the signals below. After connecting with the computer, LCD TV can automatically
recognize the signal from the connected PC (computer) / HDMI.
PC SIGNAL MODE COLUMN (recommended)®
SYSTEM MODE
VGA
SVGA
XGA
WXGA
WXGA
SXGA
(42" Full-HD only)
NOTE:
In case LCD TV can not display properly due to the connecting cable or the graphic hardware, please make
■
adjustments about phase, clock and soon.
In principle, LCD TV can not display the signal mode which not described in the above column. But sometimes it
■
can display a signal very similar with one of the signal described.
If you want to change the definition and color of PC, please select one from the column.
■
It is not the trouble of LCD TV if interference appears on the picture while switching the signal mode.
■
The Dot Clock of the computer's signal must be less than 108 MHz.
■
Specifications are subject to change without notice.
■
When the input signal from PC is out of above PC signal mode column, "No Support" caution message will display.
■
But in some case, the LCD TV still display the PC signal though the signal mode doesn't exist on above list. Under
this condition, the display position may not correct and quality may not be admitted also.
When input signal is digital from HDMI terminal, refer to the chart below.
SYSTEM MODE
480I
480P
720P/60
1080I/60
1080P/24
(42" Full-HD only)
1080P/60
(42" Full-HD only)
26
19" / 26" / 32" / 42"
Resolution
640x480
800x600
1024x768
1360x768
1280x768
1280x1024
19" / 26" / 32" / 42"
Resolution
720(1440)x480
720x480
1280x720
1920x1080
1920x1080
1920x1080
V-Freq.(Hz) H-Freq.(KHz)
59.94 31.47
60 37.88
60 48.36
60 47.712
60 47.78
60 63.981
V-Freq.(Hz) H-Freq.(KHz)
59.94 15.73
59.94 31.47
60 45
60 33.75
24 26.973
60 67.5
PIXELS CLOCK (MHz)
25.18
40
65
85.5
79.5
108
PIXELS CLOCK (MHz)
27
27
74.25
74.25
74.25
148.5