Table of Contents
Advertisement
4 Use your TV
Switching on your TV and putting it in
Standby mode
Remote Control
To Turn the TV On from Standby or Off to Standby
Press B on the Side of the Unit or the Remote Control.
●
Note(s)
Energy Consumption contributes to air and water pollution. When the AC Power Cord is
●
plugged in, your TV consumes energy with a very low Standby Power Consumption.
Adjusting Volume
Remote Control
To decrease or increase Volume
Press VOL J (–) / K(+) on the Side of the Unit or press VOL + / – on
●
the Remote Control.
VOL J (–) / – : Volume Down
VOL K (+) / + : Volume Up
To mute or unmute sound
Press MUTE on the Remote Control to mute the sound.
●
Press MUTE again or VOL + / – to recover the original sound.
●
TV
TV
Switching Channels
Remote Control
To Select Channels by using CHI / H or CHl / k
Press CH I(–) (Down) / H(+) (Up) on the Side of the Unit or press CHl / k
●
on the Remote Control.
To select Channels by using the NUMBER keys
Digital TV Operation
For Digital channels, press a number followed by a sub channel "-" and
●
the corresponding sub channel number.
When selecting Digital channel 11-1
–
Be sure to press - before entering the subchannel number.
Cable / NTSC (Analog) TV Operation
When selecting Cable or Analog channel 11
–
Press RECALL to return to the previously viewed channel.
Note(s)
To select the non-memorized channels, use the NUMBER keys.
●
No signal will appear on the TV screen after the subchannel broadcast is over.
●
Audio only program message will appear on the TV screen, when you receive only a sound
●
signal.
16
.
English
TV
Continued on next page.
Advertisement
Table of Contents
