3 Use your TV
Switching on your TV and putting it in
standby mode
TV
Remote control
To turn the TV on from standby or off to standby
Press B on the TV or the remote control.
●
Note(s)
Energy consumption contributes to air and water pollution. When the AC power cord is
●
plugged in, your TV consumes energy with a very low standby power consumption.
Adjusting volume
TV
Remote control
To decrease or increase volume
Press VOL + / – on the TV or the remote control.
●
VOL + : Volume up
VOL – : Volume down
To mute or unmute sound
Press D on the remote control to mute the sound.
●
Press D again or VOL + / – to recover the original sound.
●
Switching channels
TV
Remote control
To select channels by using CH + / –
Press CH + / – on the TV or the remote control.
●
To select channels by using the NUMBER buttons
Digital TV operation
For digital channels, press a number followed by a dot "•" and the
●
corresponding sub channel number.
When selecting digital channel 11.1
–
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV operation
When selecting cable or analog channel 11
–
Press PREV.CH to return to the previously viewed channel.
Note(s)
To select the non-memorized channels, use the NUMBER buttons.
●
Channel not available or No signal will appear on the TV screen after the subchannel
●
broadcast is over.
Audio only message will appear on the TV screen, when you receive only sound signal.
●
19
.
English
Continued on next page.