Table of Contents
Advertisement
WARNING: DO NOT FIT THe PLUG IN THe POWeR SOCKeT WITH WeT HANDS.
In the event of an extension cord being used, make sure this is in perfect condition, in compliance with Ce standards and with cable cross
section suitable for the power input of the dust collector.
1.
In order to raise the dust collector easily, NFe suggests removing the motor head.
2.
Pull the pins on each side of the dust collector one at a time and turn them until they are in the locked position.
3.
Lift the machine body using the handle.
4.
Lock the machine body turning the pins to their initial position.
If movement becomes difficult, remove the side cover, loosen the screws and if necessary, put some grease on the sliding system.
5.
6.
To lower the dust collector, reverse the above steps.
WARNING: BeFORe TRANSPORTING, ALWAYS LOWeR THe MACHINe TO TRANSPORT MODe.
17
Installation
406124_RevC
Advertisement
Table of Contents
