Setting Up The Verity Print - Hart InterCivic Verity Print Field Manual

setting up Verity Print
8

setting up the Verity Print

1. Position the Verity Print on a table next to the ballot printer.
2. Follow local procedures to the remove tamper seal from
the Verity Print handle, if applicable. Unlock the case (if
locked). Open the case and remove the power brick and
power cord from the storage compartment. Close the
compartment and case.
3. Plug the power cord into the power brick, and then plug the power brick
into the back of the Verity Print (flat side up).
IMPORTANT: Do not plug the power cord into the wall yet.
4. Plug the flat end of the USB printer cable from the ballot printer into the
back of the Verity Print, with the notch facing up.


