Table of Contents
Advertisement
setting up Verity Print
10
9.
Plug the power cord into AC power. A green light
should illuminate on the power brick when AC power is
present.
10.
Press the red button on the back of the Verity
Print to power it on.
During the power on process, a Power-On
•
Self Test report will print on Verity Print's
built-in printer. This report will indicate any
hardware or connection issues; if any issues
are noted, check connections and restart the
device using the red power button.
11.
(if applicable) If your jurisdiction uses the
AutoBallot barcode reader: Wait until the
Verity Print finishes powering up and displays
the Enter Poll Worker Code screen, and
then connect the AutoBallot barcode reader
to the USB connection located on the vDrive
compartment above the report printer.
Advertisement
Table of Contents
