Advertisement
Parts Identification
210312
PLEASE READ this guide prior to installation, to familiarise
yourself with the various stages required.
Care & Maintenance
In the unlikely event of missing or damaged parts,
hello@time4sleep.co.uk
please
email
Please have this guide at hand quoting the part
code reference numbers shown, when requesting
spare or replacement parts.
1
Page 1 of 3
SORRENTO
2 DRAWER BEDSIDE
Carefully open the pack supplied and check the
contents against the parts and fittings check list.
Do not destroy any of the packaging until you are
certain that you have all the necessary parts.
Please ensure that the packaging is disposed of in
a safe and environmentally friendly way.
Warnings
Do not place very hot or very cold items on
the furniture unless table mats are used to
prevent such items coming into direct contact
with the glass.
Do not strike the glass with hard or pointed
objects.
Do not use abrasive cleaners on the glass as
these may scratch and damage the glass.
To clean your item, use a soft cloth, slightly
dampened with water, and wipe clean. If
necessary, use a few drops of washing up liquid
on the cloth.
Then buff with a dry, clean cloth.
If the glass is chipped or broken and unsafe
to use, please contact your retailer.
Do not drag the cabinet across the floor, lift it
into position using two persons.
Advertisement
Table of Contents
Related Manuals for Time4Sleep SORRENTO
Summary of Contents for Time4Sleep SORRENTO
- Page 1 SORRENTO 2 DRAWER BEDSIDE PLEASE READ this guide prior to installation, to familiarise yourself with the various stages required. Carefully open the pack supplied and check the contents against the parts and fittings check list. Do not destroy any of the packaging until you are certain that you have all the necessary parts.
- Page 2 Parts Checklist Additional Tools Required Ref. Description 2 Drawer Bedside Chest Cross-head Screwdriver Fittings Checklist Ref. Description Ref. Description Bracket for furniture - pre-fitted by the factory. Cable tie Bracket for wall Reversing the knobs Stage The knobs are mounted inside of the drawers to protect them during transit Open the top drawer ii) Undo the screw and reverse the knob re-fitting it on the...
- Page 3 Re-fitting the knobs iii) Make sure the ferrule (x) is re- fitted inside the holes, this is to prevent cracking the glass - please do not over-tighten the screws. Repeat on the second drawer. Safety Warning Fitting instructions for anti-tilt brackets. We advise that to prevent any entrapment or unforeseen accidents, you need to secure the furniture to your wall in accordance with the following instructions.
Need help?
Do you have a question about the SORRENTO and is the answer not in the manual?
Questions and answers