Maintenance; Operation; Optional Accessories - Makita 6807 Instruction Manual

Speed change knob
► Fig.6: 1. Speed change knob 2. Pointer
Two rpm ranges can be preselected with the speed
change knob.
For low speed range (0 - 1,000/min.), turn the knob so
that the pointer points to the number 1 marked on the
knob.
For high speed range (0 - 2,200/min.), turn the knob so
that the pointer points to the number 2.
If it is hard to turn the knob, pull the switch trigger half-
way for running the tool at low speed and turn the knob
again.
CAUTION:
• Do not turn the knob while the tool is running at
full speed. Malfunction of the tool may result.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing the bit
To remove the bit, first pull the locator out of the locking
sleeve. Then grasp the bit with a pair of pliers and pull
the bit out of the magnetic bit holder. Sometimes, it
helps to wiggle the bit with the pliers as you pull.
► Fig.7: 1. Locator 2. Locking sleeve
To install the bit, push it firmly into the magnetic bit
holder. Then install the locator by pushing it firmly back
onto the locking sleeve.
► Fig.8: 1. Locator 2. Bit 3. Magnetic bit holder

OPERATION

Always use the side grip (auxiliary handle) and firmly
hold the tool by both side grip and switch handle during
operations.
Fit the screw on the point of the bit and place the point
of the screw on the surface of the workpiece to be fas-
tened. Apply pressure to the tool and start it. Withdraw
the tool as soon as the clutch cuts in. Then release the
switch trigger.
CAUTION:
• When fitting the screw onto the point of the bit,
be careful not to push in on the screw. If the
screw is pushed in, the clutch will engage and
the screw will rotate suddenly. This could dam-
age a workpiece or cause an injury.
• Make sure that the bit is inserted straight in the
screw head, or the screw and/or bit may be
damaged.

MAINTENANCE

CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
To maintain product SAFETY and RELIABILITY,
repairs, carbon brush inspection and replacement, any
other maintenance or adjustment should be performed
by Makita Authorized Service Centers, always using
Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
• These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Phillips bits
• Magnetic bit holder
• Magnetic socket bit
NOTE:
• Some items in the list may be included in the
tool package as standard accessories. They
may differ from country to country.
5 ENGLISH