How To Use; How To Clean; Troubleshooting - Panasonic ER-CBL1 Operating Instructions Manual

How to use

Note
The appliance will not operate with the AC adaptor connected.
• The appliance may not operate in an ambient temperature
lower than approximately 5 °C.
Remove the cap, mount the desired head and press the
power switch.
▪ Clean the appliance after use.
► When the remaining battery is low
The charge status lamp blinks when the power is turned off.
(It turns off after 5 seconds.)

How to clean

• Make sure that the main body is turned off.
• The AC adapter cannot be washed with water. Disconnect
the adaptor and wipe with a dry cloth.
• Do not wipe with thinner, benzine, alcohol etc. Doing so may
cause malfunction, cracking or discoloring of the parts.
• After cleaning, store the main body with the cap attached.
1
Remove the AC adaptor and head from the main body.
2
Rinse the main body with running water. (Fig. 3)
▪ Do not immerse the main body in water for a long time.
Otherwise, the water may seep into the main body.
3
Shake up and down several times to remove the water.
▪ Be careful not to hit the appliance on the sink or any other
object while draining the water.
4
Wipe off the water with a dry cloth and dry it well.
10

Troubleshooting

Problem
Appliance does not operate
even after charging.
Operating time is short
even after a full charge.
The main body cannot
be charged.
If the problems still cannot be solved, contact your dealer or a
service centre authorized by Panasonic for repair.
Action
The appliance will not operate
with the AC adaptor connected.
Please use the appliance after it
has been sufficiently charged and
the AC adaptor disconnected.
Use the appliance in an
ambient temperature
approximately 5 °C or higher.
The battery is nearing the end
of its life.
The charging time is long or the
charge status lamp will blink
quickly and the battery may fail
to charge properly in extremely
high or low temperatures.
Charge within the
recommended charging
temperature of 10 °C to 30 °C.