Panasonic DMW-HGR2 - Hand Grip Manual

Table of Contents

Introduction

Read these instructions completely and keep them for future reference.

Designed to be used with Digital Camera DC-GX9, DMC- GX80, DMC-GX85 (As of March 2018). Please check the catalog or operating instructions of your digital camera to confirm this accessory's compatibility before purchase.
Attaching the hand grip to a digital camera will improve your grip on the camera.

Attach the hand grip so that the attachment screw and the guide fit the camera properly.
Turn the attachment screw in direction of the arrow to attach securely.
- When attaching the screw, be careful not to fix it in a tilted position.
- Confirm that the attachment screw is not loose while using.

Remove the hand grip from the digital camera

To remove the hand grip, turn the attachment screw in the opposite direction of the tightening direction.

Attaching a tripod
A tripod can be used even with the hand grip attached.

Take care not to drop the hand grip or subject it to strong impact.
Before cleaning the hand grip, wipe the hand grip with a dry
- When the hand grip is soiled badly, it can be cleaned by wiping the dirt off with a wrung wet cloth, and then with a dry cloth.
- Do not use solvents such as benzine, thinner, alcohol, kitchen detergents, etc., to clean the hand grip, since it may deteriorate the hand grip or the coating may peel off.
- When using a chemical cloth, be sure to follow the accompanying instructions.
Remove the hand grip from the camera after use. Do not store the camera for a long time with the hand grip attached.
Be sure to read the operating instructions of your digital camera.