Advertisement
Notes on using the extension tube E420H
Note: The extension tube E420H is sold separately.
The extension tube E420H is compatible with the chamber E420. Combining these two matching ele-
ments, you will achieve optimal results. Not only the paint mist is filtered, but also harmful vapours are
led outside through the HS E420H tube. Thus, the air inside the work zone will be kept clean and fresh.
1. Features
a) Lightweight, easy to assemble and disassemble
b) The length of the hose can be varied from 0.7 to 1.7 m.
c) The long flat exhaust piece can be pressed to 25 mm from both sides, so that it fits in a window
or door gap.
2. Parts
19. Plastic sleeve
3. Safety instructions
CAUTION!
a) When using the extension tube, take out a filter-net layer from the device. There are two layers
of filter mesh in the spray booth, only one of which is needed when using the extension tube.
b) Unscrew the 4 screws from the protective grille on the back of the HS-E420 spray booth (see
fig. 1).
c) Use the 4 screws unscrewed in the previous step to connect the plastic sleeve to (19) with the
HS E420 spray booth (see fig. 2).
d) Screw the soft threaded sleeve (20) and extension hose (22) together and connect the exten-
sion tube to the exhaust piece (23) (see fig. 3).
e) Place the hose clamp (21) onto the soft threaded sleeve (20) and screw it into the plastic
sleeve (19) (see fig. 4).
f)
Extend the hose as you wish and place its exhaust piece outwards through a window or door
gap (see fig. 5).
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
20. Soft threaded
21. Hose clamp
sleeve
Item 34220, 34251, 34259–34263
22. Extension tube 23. Exhaust piece
Page 10
02
2022-1
Advertisement
